Air Brakes Test 2 - Crist CDL's Online Testing Center

Home Page
Online Testing Center

Knowledge Test 1
Knowledge Test 2
Knowledge Test 3
Knowledge Test 4
Knowledge Test 5
Knowledge Test 6
Knowledge Test 7
Knowledge Test 8
Knowledge Test 9
Knowledge Test 10
Knowledge Test 11

Air Brakes Test 1
Air Brakes Test 2
Air Brakes Test 3
Air Brakes Test 4
Air Brakes Test 5
Air Brakes Test 6

Haz Mat Test 1
Haz Mat Test 2
Haz Mat Test 3
Haz Mat Test 4
Haz Mat Test 5
Haz Mat Test 6
Haz Mat Test 7

Passenger Test 1
Passenger Test 2
Passenger Test 3
Passenger Test 4
Passenger Test 5
Passenger Test 6

Tanker Test 1
Tanker Test 2
Tanker Test 3
Tanker Test 4
Tanker Test 5

Doub/Trips Test 1
Doub/Trips Test 2
Doub/Trips Test 3

Combination Test 1
Combination Test 2
Combination Test 3

Air Brakes Test 2
To receive a copy of your score and the answer sheet, enter a Name and your e-mail address. Entering your e-mail address will enter you in our mailing list.

Name: (Optional)
E-mail: (Optional)

Air loss in a straight truck or bus should not be more than ____ with the engine off and the brakes on.

a. 1 psi in 30 seconds

b. 1 psi in one minute

c. 2 psi in 45 seconds

d. 3 psi in one minute

To make an emergency stop with air brakes, using the stab braking method, you should:

a. Pump the brake pedal rapidly and lightly.

b. Brake hard until the wheels lock, and then get off the brakes for as much time as the wheels were locked.

c. Brake as hard as you can, get off the brakes when the wheels lock, get back on the brakes when the wheels start rolling again.

d. Press hard on the brake pedal and apply full hand valve until you stop.

You should know that your brakes are fading when:

a. Pressure on the brake pedal is released and speed increases.

b. You have to push harder on the brake pedal to control your speed on a downgrade.

c. The brake feels spongy when pressure is applied.

d. Less pressure is needed on the brake pedal for each stop.

To check the free play of manual slack adjusters on s-cam brakes you should:

a. Park on level ground, chock the wheels, and release the parking brakes.

b. Stop on level ground and apply the parking brakes.

c. Park on level ground and drain off air pressure before adjusting.

d. Park on a slight grade, release the parking brake, apply the service brakes, and check for vehicle movement.

If the air compressor should develop a leak, what keeps the air in the tanks?

a. The tractor protection valve

b. The emergency relay valve

c. The one way check valve

d. The air compressor

Scroll down to Submit!